Cp-electronics VITP-PD Manual de usuario descargar pdf (Pagina 2)

LOAD

See datasheet for Vitesse Plus marshalling box

SUPPLY VOLTAGE 12VDC

TIME OUT PERIOD Adjustable 10 seconds to 30 minutes

LIGHT LEVEL Light to dark

FIXING METHOD Flush fixing in 64mm hole

MATERIAL Flame retardant ABS

TYPE Class 2

TEMPERATURE -10°C to 35°C

CONFORMITY EMC-89/336/EEC

LVD-73/23/EEC

LOAD DOES NOT COME ON

Check to see if the Vitesse Plus marshalling

box is powered up and the wiring is correct.

If the supply and wiring are good, check the

LUX level setting. Increase the LUX level set-

ting to allow the controller to turn on at higher

ambient natural light level.

If the detection range is smaller than expected,

check the diagram above. Rotating the sensor

slightly may improve the range.

LIGHTS DO NOT GO OFF

Ensure that the area is left unoccupied for

longer than the selected timer setting.

Make sure that the sensor is not adjacent to

circulating air, heaters or lamps.

Part Numbers

Fault Finding

Specification

Detection Pattern

VITP-PD Vitesse Plus ceiling mounted presence detector

DBB Surface mounting box

Ref #WD156 Issue 4

C.P. Electronics Ltd

Brent Crescent

London

NW10 7XR

United Kingdom

Tel: + 44 (0) 333 900 0671

Fax: + 44 (0) 333 900 0674

www.cpelectronics.co.uk

enquiry@cpelectronics.co.uk

IMPORTANT NOTICE!

This device should be installed by a

qualified electrician in accordance with

the latest edition of the IEE wiring

regulations.

Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.

FM 45789 EMS 534520

1 2

Comentarios a estos manuales

Sin comentarios

Cp-electronics VITP-PD Manual de usuario Pagina 2

Comentarios a estos manuales