Cp-electronics VITM6-EBDSPIR-DD Manual de usuario

Overview The EBDSPIR-DD PIR (passive infrared) presence detector provides automatic control of lighting loads with optional manual control. Outpu

10 Parameter Name Default Value Range / Options Description UHS5 UNLCDHS Channel 1 –Switching Channel Detection Mode Presence Presence or

11 This page intentionally left blank

12 Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior not

2 Detection diagram Area of lower sensitivity Area of high sensitivity

3 Choosing a Suitable Location The EBDSPIR-DD is designed to be ceiling mounted and must satisfy the following criteria:  Avoid positioning the un

4 Installation The UNLCDHS has the ability to read back the settings stored in a device. To read back individual parameters  Navigate to the param

5 Single channel dimming Channel 1 (switched output) of the EBDSPIR-DD can either be used to switch a separate channel of standard, non-dimming lumi

6 L/OUTLNEBDSPIR-DD SENSORSW1/UPSW2DOWNPLEASE NOTE THAT THEDIMMING SIGNAL IS USED TOSWITCH THE DIMMINGLUMINAIRE ON/OFF ANDTHEREFORE THE 240V FEEDTO

7 When power is applied to the unit, the load will turn on immediately. Set the timeout to 10 seconds, vacate the room or remain very still and wait

8 Basic programming Parameter Name Default Value 0 1 2 3 UHS5 Handset Graphics Description Button Activation On / Raise On Raise

9 Advanced programming Parameter Name Default Value Range / Options Description UHS5 UNLCDHS Detector Parameters Walk Test LED Off On or O