Cp-electronics EBDSPIR-AD Manual de usuario

page 1. Dimensions Section Contents Page 1 Dimensional information 1 2 Description and operation 2 3 Wiring and fixing 3 4 Programming 6

page 10 Area of lower sensitivity Area of high sensitivity 6. Detection Patterns

page 11 7. Fault Finding LOAD DOES NOT COME ON Check to see if the live supply to the circuit is good. Strap across the L and LIVE OUT terminal to

page 12 LOAD Channel 1 (switching): 10A of lighting and or ventilation including incandescent, fluorescent, compact fluorescent, low voltage (switch

page 2 The EBDSPIR-AD PIR (passive infrared) presence detector provides automatic control of lighting loads with optional manual control. It can be u

page 3 3. Wiring & Fixing 1. Wire the products using the diagrams shown in section 5. 2. To switch from more than one position simply wire t

page 4 FLUSH FIXING SURFACE FIXING 1 2 2 1 Hole Ø64mm Warning - be careful bending springs when mounting unit. Pull out spring tab and rotate spring

page 5 3 5 3 4 5 4 6

page 6 4. Programming All the following functions can be programmed using the remote control DD-LCDHS handset: 1. Detector Parameters (factory d

page 7 4 Dimming Channel 2 functions (factory default in brackets): 4.1 Light level Maintained illuminance level (adjustable between 1 and 999).

page 8 5.1 Single channel dimming Functions: Switches the luminaire with occupancy and maintains illuminance. Dims and switches using optional centr

page 9 5.2 Single channel switching Functions: Switches channel 1 only with occupancy, optional override switch. No dimming output. Configured to p