Cp-electronics EBDSPIR-HB-DD Manual de usuario

page 1. Dimensions Contents Section Contents Page 1 Dimensional information 1 2 Description and operation 2 3 Wiring and fixing 3 5 Prog

page 10 6.4 Single channel switching Functions: Switches channel 1 only with occupancy, optional override switch. No dimming output. Configured t

page 11 7. Detection Patterns and Aisle Mounting 8. Fault Finding LOAD DOES NOT COME ON Check to see if the live supply to the circuit is good. S

page 12 LOAD Channel 1 (switching): 10A of lighting and or ventilation including incandescent, fluorescent, compact fluorescent, low voltage (switch

page 2 The EBDSPIR-HB-DD PIR (passive infrared) presence detector provides automatic control of lighting loads with optional manual control. This pro

page 3 3. Wiring & Fixing 1. Wire the products using the diagrams shown in section 6. 2. To switch from more than one position simply wire

page 4 FLUSH FIXING SURFACE FIXING 1 2 2 1 Hole Ø64mm Warning - be careful bending springs when mounting unit. Pull out spring tab and rotate spring

page 5 3 5 3 4 5 4 6

page 6 5. Programming All the following functions can be programmed using the remote control DD-LCDHS handset: 1. Detector Parameters (factory d

page 7 4 Dimming Channel 2 functions (factory default in brackets): 4.1 Light level Maintained illuminance level (adjustable between 1 and 999).

page 8 6. Wiring Diagrams OPTION 1(B): USING A CENTRE BIASED RETRACTIVE SWITCH TO PROVIDE ABSENCE DETECTION, WILL ALSO PROVIDE OPTIONAL OVERRIDE OFF

page 9 6.2 Two channel, individual switches Functions: Switches both channels with occupancy. Maintains illuminance, dims and switches the dimming