page 1. Description and Operation Section Contents Page 1 Description and operation 1 2 Dimensions 2 3 Wiring 5 4 Setup 6 5 Programmin
page 10 4 Dimming Channel 2 functions -DD & -AD only (factory default in brackets): 4.1 Light level Maintained illuminance level (adjustable
page 11 6. Detection Patterns 7. Fault Finding LOAD DOES NOT COME ON Check to see if the live supply to the circuit is good. Strap across the L an
page 12 LOAD 2 Amps fluorescent and incandescent lighting. 2 Amps compact fluorescent lighting. 2 Amps low energy lighting. 2 Amps low voltage lighti
page 2 2. Dimensions & Mounting options The product range consists of the following items that are ordered separately:- Power supply unit Sensor
page 3 Flush mounting the sensor head using the flush mount bracket The product can be mounted into a flat panel of a luminaire using the flush moun
page 4 2. Dimensions & Mounting options cont. Flush fitting the sensor head behind a diffuser using the flange bracket Flush fitting the sensor
page 5 3. Wiring Wire the products as shown in the diagrams.
page 6 1. Connect the power supply via the terminal block on the power supply unit as shown overleaf. Live supply to the L terminal, Neutral to the
page 7 Settings adjustment:- On initial power up, the factory set default settings are:- Time = 20 minutes. Lux = Maximum (i.e. lights will switch o
page 8 Push button adjustment Time, Lux and Sensitivity Press and hold either button for at least 5 seconds then release: one of the LED‘s positione
page 9 5. Programming All the following functions can be programmed using the remote control DD-LCDHS handset: 1. Detector Parameters (factory d
Comentarios a estos manuales